Question: 1

AOS-Switches will enforce 802.1X authentication on edge ports. The company has two RADIUS servers Authentic Jordan Poole Jersey , which are meant to provide redundancy and load sharing of requests. The exhibit shows the planned RADIUS settings to deploy to the switches.
What should customers understand about this plan?

A. AOS switches do not support two RADIUS servers for redundancy, instead, a secondary authentication method is required.
B. Dynamic authentication is only permitted on one of the RADIUS servers and must be removed from the other.
C. Each RADIUS server must use a unique port number for the authentication and dynamic authorization port.
D. Each AOS-Switch will send all RADIUS requests to the first server on the list unless that server becomes unreachable.

Answer: D

Question: 2

An administrator wants to ensure that an AOS-Switch forwards all traffic that it receives on interface 1 with high priority.
- Switches should also communicate the high priority to other switches across the traffic path.
- The switch has type of service disabled.
- The administrator plans to apply 802.1p priority 5 to interface 1.
What should the administrator check to ensure that the configuration will work properly?

A. Interface 1 receives traffic with a tag.
B. The AOS-Switch is configured to use eight queues.
C. The forwarding path for the traffic uses VLAN tags.
D. An 802.1p-to-DSCP map exists for priority 5.

Answer: A

Question: 3

A network administrator sets up prioritization for an application that runs between Device 1 and Device 2. However Authentic Nate Thurmond Jersey , the QoS for the application is not what the administrator expects.
How can the administrator check if the network infrastructure prioritizes traffic from Device 1 and Device 2?

A. Run a packet capture on Device 2, run the application, and look in the packet capture for a high value DSCP in the IP header.
B. Set up RMON alarms on the switches that trigger when a high number of packets are dropped. Then Authentic Rick Barry Jersey , run the application and check for the alarm.
C. Clear interface statistics on the switches. Then, run the application and check the interface queue statistics for the switch-to-switch links.
D. Run a packet capture on Device 1, run the application Authentic Mitch Richmond Jersey , and look in the packet capture for a high value DSCP in the IP header.

Answer: A

Question: 4

The exhibits show the current operational state for routes on Switch-3. The company wants Switch-3 to prefer the link to Switch-1 over the link to Switch-2 for all intra-area, inter-area, and external traffic.
What can the network administrator do to achieve this goal?

A. Set the OSPF cost on VLAN 108 higher than 1 on Switch-2 and Switch-3.
B. Set the OSPF administrative distance on Switch-2 higher than 110.
C. Set the OSPF area type to normal on all of the switches in Area 1.
D. Set the cost in the OSPF Area 1 stub command higher than 1 on Switch-2.

Answer: D

Question: 5

An AOS-Switch implements tunneled node.
Which benefit does the PAPI enhanced security key provide?

A. It validates the signature for firmware pushed to the switch dynamically.
B. It encrypts traffic sent and received by tunneled-node endpoints.
C. It authenticates control traffic between the switch and its Mobility Controller.
D. It provides an extra layer of authentication for endpoints on tunneled-node ports.

Answer: C

Question: 6

A network administrator needs to deploy AOS-Switches that implement port-based tunneled node. Their Aruba controller has IP address 10.1.10.524. The architect has assigned tunneled-node endpoints to VLAN 20.
What is one issue with the current configuration planned for VLAN 20 on the switch?

A. VLAN 20 must have GRE enabled on it.
B. VLAN 20 cannot have an IP address.
C. VLAN 20 must have an IP address in the same subnet as the controller.
D. VLAN 20 must not enable jumbo frames.

Answer: D

Question: 7

OSPF Area 1 has two ABRs. One ABR is configured with this range for Area 1: 10.10.0.016. The other ABR is not configured with a range for Area 1.
Which type of issue occurs due to this mismatch?

A. The ABRs create a discontinuous area and disrupt intra-area routing between devices within Area 1.
B. The ABR core would send Area 1 traffic destined to the other switch through an access switch.
C. The ABRs lose adjacency entirely and cannot route traffic between each other at all.
D. The ABRs lose adjacency in Area 1 and must route all traffic to each other through Area 0.

Answer: A

Total Views: 51Word Count: 722See All articles From Author
"What's the Buzz About?"

"I made $5 Authentic Chris Mullin Jersey ,000 in one week"

"I quit my job and spend more time with my kids"

It sounds too good to be true, but if you're serious about working from home and you don't have a lot of money to start than keep reading?

"What IS an Affiliate?"

Basically, an Affiliate is an individual that is willing to market and promote another company in exchange for a commission.

An affiliate is NOT an employee of the company. There are no guarantees of earnings in most cases Authentic Latrell Sprewell Jersey , and there are various methods of determining payments.

In most cases, the company presents the affiliate with a link to its site that has a special code. When this link is promoted and customers click on that link, the company can trace any sales or leads back to the affiliate. Commissions can be made either way depending on the nature of the business. Good affiliate programs will offer a period of time in which Authentic Wilt Chamberlain Jersey , if the customer does not purchase the first time, but comes ba. Cheap Nike Shoes   Cheap Nike Air Max   Cheap Air Max 97   Cheap Air Max Shoes   Cheap Nike Air Max Shoes   Jordan 11 Shoes For Sale   Air Max 2018 Outlet   Cheap Jerseys   Cheap Jerseys From China   Wholesale NFL Jerseys Free Shipping